Hilti TE 2000-AVR User Manual

English 13
8.1 Troubleshooting table
Trouble or fault Possible cause Action to be taken
The power tool doesn’t start. Electronics initialization in progress
(takes up to 4 seconds after plug-
ging in).
▶ Switch the power tool off and
on again.
Interruption in the electric supply. ▶ Plug in another electric ap-
pliance and check whether it
works.
The supply cord or plug is defec-
tive.
▶ Have the parts checked by a
trained electrical specialist and
replaced if necessary.
Generator with sleep mode ▶ Apply a load to the generator
by connecting a second power
consumer (e.g. worklight). Then
switch the power tool on and off
again.
No hammering action. The power tool is too cold. ▶ Allow the power tool to warm
up to the minimum operating
temperature.
A fault has occurred in the power
tool.
▶ Have the power tool repaired by
Hilti Service.
The power tool doesn’t start
or cuts out while in operation
and the indicator flashes red.
Temporary fault (e.g. overheating
or overvoltage).
▶ Switch off, allow the power tool
to cool down or connect it to a
different electric supply.
The power tool runs but the
indicator lights red continu-
ously.
Advance warning of need for ser-
vicing.
▶ Have the power tool serviced or
repaired by Hilti Service.
The power tool doesn’t start
or cuts out while in operation.
The extension cord is too long
and/or its gauge is inadequate.
▶ Use an extension cord of an
approved length and/or of
adequate gauge.
The detachable supply cord is not
fitted correctly.
▶ Fit the detachable supply cord
to the power tool correctly.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
10 RoHS (Restriction of Hazardous Substances)
Click on the link to go to the table of hazardous substances: qr.hilti.com/r6025050.
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
11 Manufacturer’s warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Printed: 20.05.2019 | Doc-Nr: PUB / 5333035 / 000 / 04

Hilti TE 2000-AVR Specifications

General

Input power	2100 W
Power source	AC
Power plug type	Type C
Impact energy (max)	32 J
Idle impact rate (max)	1800 IPM
Vibration level (chiseling)	4.8 m/s²
Toolholder	- mm
Product color	Black, Red
Country of origin	Germany
Quantity per shipping (inner) case	1 pc(s)

Weight and Dimensions

Depth	731 mm
Width	574 mm
Height	146 mm
Weight	14500 g
Package depth	100 mm
Package width	150 mm
Package height	76 mm
Package weight	500 g