Hilti WSR 900-PE User Manual (English)

Other manuals for Hilti WSR 900-PE

Questions and Answers:

K
Kristin PhillipsAug 12, 2025
Why Hilti WSR 900-PE won't start?
- M
  Mr. Jonathan WestAug 12, 2025
  The Hilti Saw might not start due to a few reasons: * There may be an interruption in the electrical supply. To check this, plug in another power tool or appliance to see if it works. * The supply cord or plug could be defective. If this is the case, have the tool repaired only by a Hilti Service Center. * The control switch might be defective. In this instance, have the tool repaired only by a Hilti Service Center.
J
josephgordonAug 17, 2025
What to do if Hilti WSR 900-PE does not achieve full power?
- E
  emilynelsonAug 17, 2025
  If the Hilti Saw doesn't achieve full power, consider these possibilities: 1. The extension cord might be too long or have an inadequate gauge. Use only approved extension cords with adequate gauge conductors. 2. The control switch may not be fully pressed. Ensure you press the control switch completely.
M
Michelle Warren MDAug 25, 2025
How to remove saw blade from Hilti WSR 900-PE chuck?
- E
  ejohnsonAug 25, 2025
  If you're having trouble removing the saw blade from the Hilti Saw chuck, it might be because the locking sleeve isn't turned as far as it can go. Turn the locking sleeve completely, and then try removing the saw blade.
M
Michael CantuAug 30, 2025
What to do if contact shoe or pipe-cutting adapter cannot be removed from Hilti Saw?
- B
  Briana OconnellAug 30, 2025
  If the contact shoe or pipe-cutting adapter cannot be removed from your Hilti Saw: * It might be prevented by the saw blade. Remove the saw blade first, and then try removing the contact shoe. * The pushbutton may not be pressed in all the way. Ensure you press the pushbutton fully before attempting to remove the saw blade.
S
Shelley RochaSep 4, 2025
Why orbital-action function does not react in Hilti WSR 900-PE?
- C
  Christopher LeonSep 4, 2025
  The orbital-action function might not react because the orbital-action switch is not in the correct position. Move the orbital-action switch to the position for orbital action. Note that orbital action is only perceptible when the saw is cutting.