Why does my Hilti SB 4-A22 not have full power?
If your Hilti Saw doesn't develop full power, make sure the control switch is fully pressed. If that doesn't solve the issue, the battery might be discharged. Try changing the battery and charging the empty one.
What to do if 4 LEDs flash on my Hilti Saw?
If 4 LEDs are flashing on your Hilti Saw, it could be due to several reasons: 1. The bandsaw might have been momentarily overloaded. If this is the case, release the control switch and then press it again. 2. The bandsaw may be too hot. Allow it to cool down. 3. The tool might be blocked. Check whether the saw blade is fitted correctly or if it's damaged.
How to fix no LED response on a Hilti SB 4-A22 Saw?
If the LEDs on your Hilti Saw aren't responding, there could be a few reasons: * The battery might not be correctly inserted. Push the battery in until you hear a double click. * The battery could be empty. Try charging it. * The safety lock might not be pressed. Ensure you press the safety lock.
Why is 1 LED flashing on my Hilti SB 4-A22 Saw?
If 1 LED flashes on your Hilti Saw, it might be because the battery is discharged. Try changing the battery and charging the empty one. Alternatively, the battery could be too hot or too cold. Bring the battery to the recommended working temperature.
Read before initial operation for safe handling and use.
Explains signal words (DANGER, WARNING, CAUTION) and document symbols.
Lists symbols that can be used on the product itself.
Read all safety warnings, instructions, illustrations, and specifications provided with this power tool.
Specific safety guidelines for operating bandsaws, covering personal and electrical safety.
Precautions for handling the tool when cutting accessories may contact hidden wiring.
Observe regulations for transport, storage, and use of Li-ion batteries.
Diagram illustrating the components of the SB 4-A22 bandsaw.
Detailed list of parts for the SB 4-A22 bandsaw with numbered references.
Specifies the product is a cordless bandsaw for cutting metals and plastics, for two-handed operation.
Lists applications where the power tool should not be used, like cutting concrete or pipes with liquids.
Explains LED indicators for battery charge state and tool malfunctions.
Technical specifications for the SB 4-A22 bandsaw, including voltage, temperature, weight, speed, and dimensions.
Technical specifications for the battery, including operating voltage, temperature, and charging parameters.
Details measured sound pressure and vibration levels according to EN 60745.
Instructions for charging the battery, ensuring clean contacts and using an approved charger.
Procedure for inserting the battery, with safety warnings for short-circuit and falling battery.
Steps to remove the battery by pressing release buttons and pulling forward.
Safety precautions before inserting battery, such as ensuring the product is switched off.
Instructions for fitting the bandsaw blade, with warnings about suitability, damage, and injury risk.
Instructions for fitting the side handle, with a caution about loss of control if not fitted.
Steps to replace the rubber ring on the roller for the bandsaw blade.
Procedure to switch on the tool by pressing the safety lock and then the control switch.
Instructions for switching off the tool by releasing the control switch, with a warning about saw run-on.
Instructions for aligning the workpiece with the bandsaw, noting incorrect alignment increases kickback risk.
Guidelines for cleaning the tool and Li-ion batteries, and general maintenance checks.
Precautions for transporting and storing cordless tools, especially regarding battery removal.
Lists possible causes and actions for malfunctions when the bandsaw is not working.
Lists possible causes and actions for troubleshooting when the bandsaw is not developing full power.
Instructions for proper disposal of batteries, emphasizing safety and environmental regulations.
General| Battery voltage | 21.6 V |
|---|---|
| Weight | 1.9 kg |
| Battery type | Li-ion |
| Stroke rate | 0-3000 strokes/min |
| No-load Speed | 2700 strokes/minute |
To Next Page
