148
Replacing the Tip Pin of the Test Lead
10.6 Replacing the Tip Pin of the Test
Lead
The conductive contact pin is replaceable. Replace the pin with a
new one if it is broken or worn.
The 9465-90 Tip Pin, a single-piece construction of a conductive
contact pin and a plastic pin base, is available at extra cost.
For the 9465-10
1
Turn o the instrument and remove the test lead.
2
Rotate the collet nut to loose, letting the cable be unxed.
(The cable has been xed by tightening the collet nut.)
(1)
(2)
Model 9465-90 Tip Pin
To prevent a wire brake . . .
• Do not pull the cable.
• Do not twist the cable.
3
While pinching the pin base so that the cable dose not
twist, rotate the grip to loosen.
(1)
(2) (3)
Pinch the pin base tightly.
Beware of risk of
injury from sharp end.
HIOKI BT3554F961-00HIOKI BT3554F961-00
To Next Page
Loading...
