Hioki DT4261 - Summary of Commands

DT4261 DIGITAL MULTIMETER Remote Operation Manual
P5/11
4. Summary of Commands
Table.3
Command
Parameter
Description
QPID
Query the Meter model.
*IDN
Query the Meter identification.
:SYST:RST
Put the meter to reset.
:SYST:LLO
Put the meter into the local lockout state.
:SYST:GTL
Put the meter into the local state.
:CONF?
Query the main function of the display.
:CONF2?
Query the sub function of the display.
:CONF
<function,range>
Configure the range.
:FETCCNT?
Query main measured count value.
:FETCCNT2?
Query sub measured count value.
:CALC:STAT:MAX?
Query measured maximum count value.
:CALC:STAT:MIN?
Query measured minimum count value.
:CALC:STAT:AVER?
Query measured average count value.
:CALC:STAT:PEAKMAX?
Query measured maximum peak count
value.
:CALC:STAT:PEAKMIN?
Query measured minimum peak count value.
:SYST:APS
<0|1>
Set the APS.
:SYST:BEEP
<0|1>
Set the action of the beeper.
:SYST:BLIT
<0|1>
Set the backlight.
:SYST:BLA
<0|1>
Set the auto backlight.
:SYST:BATT?
Query the battery level.
:SYST:ZEROADJ
<0|1>
Execute zero adjustment.
:SYST:FILTER
<0|1>,<100|500>
Set the filter.
:MEAS:AUTOV?
Query the status DC or AC of AutoV
function.
:SYST:INIT
Put the meter to power-on-reset state.
:STAT?
Query the status of the meter.