Hioki DT4280 Series - Page 7

DT4281,DT4282 DIGITAL MULTIMETER Remote Operation Manual
P7/14
Command
Explanation
:FETCCNT?
:FETCCNT2?
Query measured count value.
Syntax :FETCCNT? [:FETCCNT2?]
Response <data×1>
<data> count value
Example; “3000”
:CALC:STAT:MAX?
Query measured maximum count value. (1)
Syntax :CALC:STAT:MAX?
Response <data×1>
<data> count value
Example; “5000”
:CALC:STAT:MIN?
Query measured minimum count value. (1)
Syntax :CALC:STAT:MIN?
Response <data×1>
<data> count value
Example; “2000”
:CALC:REL:OFFS?
:CALC:REL:OFFS2?
Query the offset value of the relative. (main or sub)
Syntax :CALC:REL:OFFS? [:CALC:REL:OFFS2?]
Response <data×2>
<data> offset value, range
Example; “20, 600m”
:SYST:APS
Set the APS.
Syntax :SYST:APS <data×1>
<data> “0” (off) or “1” (on)
Example; “:SYST:APS 1”
Response “OK” or “CMD ERR”
:SYST:BEEP
Set the action of the beeper.
Syntax :SYST:BEEP <data×1>
<data> “0” (off) or “1” (on)
Example; “:SYST:BEEP 1”
Response “OK” or “CMD ERR”
:SYST:BLIT
Set the backlight.
Syntax :SYST:BLIT <data×1>
<data> “0” (off) or “1” (on)
Example; “:SYST:BLIT 1”
Response “OK” or “CMD ERR”
(1) Since the internal count value is returned, the value beyond the display range is not
guaranteed to be accurate.