Do you have a question about the Hirobo X.R.B. Lama and is the answer not in the manual?
Ensure M2 x 8PH screw and M2 nylon nut are fastened, allowing slight blade drag.
Verify that the servo moves smoothly and check the shoulder screw gap.
Ensure the motor rotates without abnormal noise, checking gear deformation and backlash.
Confirm the adapter works correctly during slow rotation and throttle opening.
Check blade overlap and adjust rudder sub trim to turn off LED.
Adjust upper rotor head for smooth left/right pirouette at the same rate.
Adjust aileron sub trim for neutral fuselage movement with aileron stick neutral.
Adjust elevator sub trim for neutral forward/backward movement with elevator stick neutral.
Check for vibration, MISOSURI, blade balance, and mast straightness.
Fix MISOSURI by checking rod ends and center hub for smooth movement.