Sensor Calibration
© 2009 Hirschmann Automation and Control GmbH · Branch Office Ettlingen · eMail: info.ecs@hirschmann.de · www.hirschmann.com 7
24 183 69 1012e (Generic) / 2009-02-26 / Rev. 01 / rk.
After entering the service menu you can follow the calibration procedure step by step or can select
the type of calibration by scrolling with function key
. Press "ESC" to finish calibration procedure:
3.1) pressure
signal piston side
… and rod side 3.2) slewing angle
signal
3.3) boom length
signal
3.4) boom angle
signal
To Next Page
Loading...
