Sensor Calibration
© 2009 Hirschmann Automation and Control GmbH · Branch Office Ettlingen · eMail: info.ecs@hirschmann.de · www.hirschmann.com 6
24 183 69 1012e (Generic) / 2009-02-26 / Rev. 01 / rk.
3. Sensor Calibration
In this code-protected area, settings affecting system precision can be made by trained service
personnel. For access to the calibration menus it is necessary to input a matching 5-digit code.
To start the function:
▼ Info screen
Actuate the INFO key.
to service menus
back
▼ Entry to calibration menus
abort input of service code
increase marked numeric value
reduce marked numeric value
mark the next figure, access after the last valid figure
If an invalid service code is entered, you are prompted to enter it again or to abort the input.
To Next Page
Loading...
