Basic Settings
RM Web L2B
Release
5.3
05/2012
1.2
Network
23
Figure 8: Network parameters dialog
Under “Mode”, you enter where the device gets its IP parameters:
In the BOOTP mode, the configuration is via a BOOTP or DHCP
server on the basis of the MAC address of the device (see on page 33
“Loading/Saving the Configuration”).
In the DHCP mode, the configuration is via a DHCP server on the
basis of the MAC address or the name of the device (see on page 33
“Loading/Saving the Configuration”).
In the local mode the net parameters in the device memory are used.
Enter the parameters on the right according to the selected mode.
You enter the name applicable to the DHCP protocol in the “Name” line in
the system dialog of the Web-based interface.
The HiDiscovery protocol allows you to allocate an IP address to the
device on the basis of its MAC address. Activate the HiDiscovery protocol
if you want to allocate an IP address to the device from your PC with the
enclosed HiDiscovery software (state on delivery: operation “on”, access
“read-write”).
To Next Page
Loading...
Need help?
General
