Installation OS20/OS30
Release
03
06/2015
7
Relevant for North America:
The device may only be connected to a Class 2 supply voltage that fulfills
the requirements of the National Electrical Code, Table 11(b). If the
voltage is being supplied redundantly (two different voltage sources), the
combined supply voltages must fulfill the requirements of the National
Electrical Code, Table 11(b).
Relevant for North America: For use in Class 2 circuits.
Only use copper wire/conductors of class 1, 75 °C (167 °F).
Relevant for installations under UL conditions:
Supply voltage: 19.2 V DC to 28.8 V DC
CE marking
The labeled devices comply with the regulations contained in the following
European directive(s):
2011/65/EU (RoHS)
Directive of the European Parliament and of the Council on the restriction
of the use of certain hazardous substances in electrical and electronic
equipment.
2004/108/EC (EMC)
Directive of the European Parliament and the council for standardizing the
regulations of member states with regard to electromagnetic
compatibility.
In accordance with the above-named EU directive(s), the EU conformity
declaration will be at the disposal of the relevant authorities at the
following address:
Hirschmann Automation and Control GmbH
Stuttgarter Str. 45-51
72654 Neckartenzlingen
Germany
Tel.: +49 1805 141538
The device can be used in the industrial sector.
Interference immunity: EN 61000-6-2
Emitted interference: EN 55022
You find more information on technical standards here:
“Technical data” on page 30
The assembly guidelines provided in these instructions must be strictly
adhered to in order to observe the EMC threshold values.
To Next Page
Loading...
Need help?
General
