Hirschmann PAT DS 85/0002 - Page 55

© Hirschmann Rev. G 10/05/15 190166_G.DOCXG
49
Error Code
Error
Possible Cause
Elimination
E22
Upper limit value in
measuring channel
“pressure piston
side” has been
exceeded
 refer to E12
 refer to E12
E23
Upper limit value in
measuring channel
“pressure rod side”
has been exceeded.
 refer to E12
 refer to E12
E24
Upper limit value in
measuring channel
“force” has been
exceeded.
 refer to E14
 refer to E14
E25
Upper limit value in
measuring channel
“main boom angle”
has been exceeded.
 refer to E15
 refer to E15
E26
Upper limit value in
measuring channel
“angle 2” has been
exceeded.
 refer to E16
 refer to E16
E27
Upper limit value in
measuring channel
“length telescope I
(+II) has been
exceeded.
 refer to E17
 refer to E17
E2A
Upper limit value in
measuring channel
“slewing angle 1”
has been exceeded
 refer to E1A
 refer to E1A
E2B
Upper limit value in
measuring channel
“slewing angle 2”
has been exceeded
 refer to E1A
 refer to E1A
E31
Error in the system
program
 The system program file
is defective.
 Flash-EPROM defective
 Upload valid system
software
 Replace central unit
E37
Error in the logical
program flow
 System program file is
defective
 Flash-EPROM defective
 Upload valid system
software
 Replace central unit
E38
System program
and crane data file
do not match.
 The system program in
the LMI does not match to
the programming in the
crane data file
 Upload valid system
program file or the valid
crane data file
E39
System program
and load chart file
do not match
 The system program in
the LMI and the
programming in the load
chart file do not match.
 Upload valid system
program file or the valid
load chart file