Hirschmann PAT DS 85/0002 - Page 56

Service Manual DS 85
© Hirschmann Rev.G 10/05/15 190166_G.DOCXG
50
Error Code
Error
Possible Cause
Elimination
E43
Error in the
write/read memory,
(RAM)
 Write/read memory
(RAM) or central unit
defective.
 Replace central unit
E47
Error in the
monitored write/
read memory.
The CRC
verification of the
monitored
write/read memory
provides an
incoherent result
 The CRC sign of the
monitored write/read
memory is wrong
 The buffer battery is
discharged (< 2V at
1kOhm).
 Central unit defective.
 Restart the LMI
 Replace buffer battery
on the central unit.
 Replace central unit
E51
Error in the crane
data file
 No valid data in the crane
data file.
 Flash-EPROM defective
 Upload valid crane data
file
 Replace central unit
E52
Error in load chart
file.
 No valid data in the load
chart file
 Flash-EPROM defective
 Upload valid load chart
file
 Replace central unit
E56
Error in crane data
file.
 No valid data in the crane
data file during
calibration.
 Flash-EPROM defective
 Restore or upload valid
crane data file
 Replace central unit
E57
Error in serial crane
data file.
 Calibration data file does
not contain valid data.
 Flash-EPROM defective
 Upload calibration data
file
 Replace central unit
E60
The number of the
selected File base
and the
programmed value
are not identical
 No valid data in the load
chart file
 Upload valid load chart
file
 Base number not
programmed
 Program the correct
base number (1 for
base 1, 2 for base 2)
 Load chart file wrongly
programmed
 Check base
programming in the load
chart file.
E61
Error in the CAN
bus data transfer for
all CAN units
 CAN Bus cable between
the central unit and the
sensor units defective or
not connected.
 Check the connection
between the central unit
and the sensor units
(wiring harness). See
section CAN-Bus
Communication
 Short circuit in a CAN Bus
cable
 Replace Can Bus cable