Hirschmann PAT DS 85/0002 - Page 57

© Hirschmann Rev. G 10/05/15 190166_G.DOCXG
51
Error Code
Error
Possible Cause
Elimination
 Can bus port in the
central unit defective
 Replace the central unit
 Blown fuse in console
 Replace 2 amp fuse
E62
Error in the can bus
data transfer of the
pressure transducer
sensor unit
 Cable between the
central unit and the
sensor unit defective or
not connected.
 Check the cable to the
sensor unit (wiring
harness). See section
CAN-Bus
Communication
 Blown fuse in console
 Replace 2 amp fuse
 Sensor unit is defective
 Replace the sensor unit
E63
Error in the can bus
pressure transducer
sensor unit
 The analog values of the
sensor unit are invalid
 Replace the sensor unit
See section CAN-Bus
Communication.
E64
Error in the can bus
data transfer of the
length/angle sensor
unit
 Cable between the
pressure transducer and
cable reel defective or not
connected.
 Check the cable to the
sensor unit. See section
CAN-Bus
Communication
 Sensor unit is defective
 Replace the electronic
board in the cable reel,
see section CAN-Bus
Communication
E65
Error in the can bus
length/angle sensor
unit
 Angle sensor defective
 Replace the angle
sensor, see section
CAN-Bus
Communication
 Length sensor defective
 Replace the length
sensor, see section
CAN-Bus
Communication
 Sensor unit is defective
 Replace the electronic
board in the cable reel,
see section CAN-Bus
Communication
E66
Error in the can bus
data transfer of the
2
nd
length/angle
sensor unit
 See E62
 See E62
E67
Error in the can bus
of the 2
nd
length
/angle sensor unit
 See E63
 See E63
E68
Error in the can bus
data transfer of the
force sensor unit
 See E62
 See E62
E69
Error in the can bus
force sensor unit
 See E63
 See E63