14
Installation RS20/22/30/32/40
Release
05
12/2015
When the temperature under rated conditions exceeds 70 °C at the
cable or conduit entry point, or 80 °C at the branching point of the
conductors, the temperature specification of the selected cable and
cable entries shall be in compliance with the actual measured
temperature values.
Make provisions to prevent the voltage of the rated voltage
connections from exceeding the 119 V threshold due to transient
disturbances.
Connectors shall be connected or disconnected exclusively in dead-
voltage state.
DIP switches must be actuated in
de-energized stated only.
The USB port shall remain disconnected.
To Next Page
Loading...
Need help?
General
