6
Do not connect the washing machine to an electrical outlet
intended for an electric shaver or hair dryer.
The power socket has to be safely earthed, and the water supply
should be unimpeded.
Do not install the washing machine in a room where the
temperature can drop to below 5°C, as washing machine parts
may be damaged in case of water freezing.
Place the washing machine on a level and stable solid (concrete)
base.
If the washing machine is placed on an elevated stable base, the
washing machine has to be additionally secured against tipping.
Before the first use of the washing machine, remove the
transport screws, as switching on a blocked washing machine
can result in serious damage (see chapter »INSTALLATION AND
CONNECTION/Removing the transport screws/rods«). Warranty
shall be void in cases of such damage.
To connect the washing machine to water supply, make
sure to use the supplied water supply hose and gaskets. Water
pressure has to be between 0.1-1 MPa (1-10 bar; 1-10 kp/cm
2
;
10-100 N/cm
2
).
Always use a new water supply hose to connect the washing
machine to water supply; do not reuse an old water supply hose.
The end of the water discharge hose should reach into a water
drain line.
To Next Page
Loading...
Need help?
General