2
Installing the Stand or Wall mount bracket
CAUTION
Be sure to disconnect the A/C power cord before installing a stand or Wall-Mount
brackets.
The screen display is very fragile, and must be protected at all times when installing
the base stand. Be sure that no hard or sharp object, or anything that could scratch
or damage the screen display, comes into contact with it. DO NOT exert pressure on
the front of the TV at any time because the screen could crack.
Follow the illustrations and textual instructions below to complete the installation steps:
1. Carefully place your TV face-down on a soft, flat surface to prevent damage to the
TV or scratching to the screen.
2. Remove the Base Stand from the accessory bag and then insert the stands into the
bottom slots of the TV.
3. Secure the Base Stand to the TV with the screws in accessory tightly.
Installing the Stand
Base Stand
Screws
： （
M4×16) × 4 (43")
（
M4×12) × 4 (50"/55")
Base Stand
43"/50"/55"
To Next Page
Loading...
