4.2.2 Novatek USB-serial driver
It’s the same as Mstar bebug Tool.
If First use Mstar bebug Tool, you have to install drive software for bebug board.
If your PC is Windows XP system:
First install FTCUNIN.EXE of FTC100103(MSTAR) rar file in your PC.
This is a drive software of Mstar
Another:
If your PC is Win7 system, you will have to install CDM20802_Setup_WIN7 rar file，and then open the
software of SecureCRT in your PC.
4.2.3 Stop board serial connect with SecureCRT
Run SecureCRT,printing information includes three status:Mboot\Supernova\no print information.
Current steps:
1) Run SecureCRT.exe
2) TV power on.
3) SecureCR tool print information can appear or not.
How to distribute the three status?
1) appearing “N62020_A32_SEC>” that meaning is in Mboot status;
2) Rolling many informmation automatically that meaning is in Supernova status;
3) No any print information that meaning the eMMC of board is no program.
Stop board serial with SecureCRT
1) In mboot status:
N62020_A32_SEC>
Input “shift” and “~” key to ensure, then close the SecureCRT window.
2) If no any print information with SecureCRT,then can directly close the SecureCRT window.
To Next Page
Loading...
