Hisense WFMC6010E - PROGRAMME SETTINGS AND OPTIONS; Add detergents, close the door and select the programme; Select any desired option

If the door can be opened in the process, door lock indicator light will flashes. Until
door lock indicator turns off, you can open the door to load clothes.
Switch on and select programme required and corresponding function keys, then
press the “Start/Pause” button to run the programme.
Delay End function allows to run the machine at the consumers convenience, for
example, at night when electricity is cheaper.
Select programme, temperature and options.
In standby mode, press and hold "Temp."+"Spin" to enter or cancel the Delay
end mode, press “Temp.” to reduce the reservation time, and press "Spin" to
increase the reservation time. After reservation function is selected, "Temp."
and "Spin" can no longer change the program slave parameters. Each time
the key is pressed, time changes for 3 hour.Reservation time is 3 to 12
hours.After reservation is set, if other parameters such as temperature,
rotating speed or function are adjusted, reservation will be cancelled. When
rotating the knob to change program, reservation will be cancelled.Reservation
time is the time when it ends, i.e. washing time is included, so reservation time
must be more than washing time.
The Delay End indicator light stays on when the programme starts.
When the time counts down to the total wash time, the Delay End indicator light turns
off
and the washing starts.
To cancel
Delay End, turn programme selector to another programme position,
before pressing “Start/Pause”
button.
21
8.5 Reload in process
Press “Start/Pause” button to reload clothes in the process of washing.
8.3 Delay End
8.4 Programme Start
Suitable for heavily soiled (e.g., soil, dust). The programme is prolonged for
20 minutes.
The programme defaults to the partial max. spin speed.
Press buttons to select other spin speeds.
If spin speed “ ” selected, the last spin process will be canceled and the machine
Each programme is corresponding to its default temperature. If needed, press
“Temp.” button to adjust.
Prewash
Spin
only dewaters before the end of programme.
Temp.