Hitachi 22LD3750DC - Page 28

- 27 -
After APS is finalized, the programme table
will appear on the screen. In the programme
table you will see the programme numbers
and names assigned to the programmes.
If you do not accept the locations and/or the
programme names, you can change them via
Program Table. See Install Menu section.
All channels found are stored in a sorted form
with respect to their channel numbers. Some
services may not appear with the correct
channel number. This is because some
broadcasters have no channel number
information.
Manual Search
In Manual Search, the number of the multiplex
is entered manually and only that multiplex is
searched for the channels. For every valid
channel number, signal level, signal quality
and network name are shown at the bottom
of the screen.
In both manual and auto search any existing
channel in the database is not re-stored to
avoid redundant duplicates of that channel.
Clear Service List (*)
(*) This setting is visible only when the Country
option is set to Denmark, Sweden, Norway or
Finland.
Use this setting to clear channels stored.
Press
a
or
b
button to select Clear Service
List and then press OK. The following OSD
will be displayed on the screen:
$UH\RXVXUH\RXZDQWWRGHOHWHDOOFKDQQHOV"
<HV 1R
Press OK to cancel.
Select Yes by pressing
_
or
`
button and
press OK to delete all of the channels.
First Time Installation
The user can use this item to load default
settings, which were loaded to the receiver at
the factory.
To install factory settings, highlight First Time
Installation menu item and press OK button,
then you will be asked whether or not to delete
the settings. Selecting Yes by pressing OK
button while the Yes is highlighted will delete
the existing channel table.
$UH\RXVXUH\RXZDQWWRGHOHWHDOOFKDQQHOVDQG
VHWWLQJVIRUILUVWWLPHLQVWDOODWLRQ"
<HV
1R
After factory settings are loaded, First Time
Installation menu will be displayed.
The menu which is displayed for language
selection appears on the screen at first. By
using
a
or
b
buttons, select the desired
language option, and press OK button to
activate.
After the language is selected, a message
asking for automatic search appears on the
screen:
'R\RXZDQWWRVWDUWDXWRPDWLFVHDUFKIRU',*,7$/FKDQQHOV"
<HV 1R
Highlight Yes item by pressing
_
or
`
buttons
and press OK button to start installation. After
search is completed for digital channels, a
message asking whether to search for
analogue channels appears on the screen:
<HV
'R\RXZDQWWRVHDUFKIRU
DQDORJXHFKDQQHOV"
1R
Highlight Yes item by pressing
_
or
`
buttons
and press OK button to search for analogue
ENG-01-TV-22784W-1165UK-MB29-PEUIDTV-(1SCRT-AV-YPBPR-HP-SPDIF-STRLOUT-PCIN)-10060401-5013xxxx.p6511.10.2008, 17:3727
All manuals and user guides at all-guides.com