Hitachi 40E31 - How to Attach the Stand; How to Remove the Stand

7 EN
How to attach the stand
NOTE:
• Assure the AC cord is not connected to an AC outlet.
• Before beginning this process, make sure that you have a clean, safe, and cushioned space to work at to avoid any damage to the
unit.
• Do not touch or press the LED screen, the glass might break under pressure.
1 Carefully place the TV screen face-down on a clean, cushioned surface.
2 Insert and secure the stands (R and L) with 2 screws (supplied) each side as shown in Figure 1.
• Be sure to follow the above instructions. Insucient tightening or incorrect installation of the stand will not support your TV correctly,
and could result in damage or injury from tip-over.
Figure 1
Stands
L
R
Screws
Screws
How to remove the stand
When you transport this product, remove the stand and pack it at against the back of the unit in the carton. To remove the stand,
perform the above steps in reverse order.
When you mount the TV on the wall, remove both stands (R and L). To disconnect the stand remove the screws from the bottom of TV.
Stands