Hitachi C 10FL - Push Stick Pattern

– 26 –
English
PUSH STICK CONSTRUCTION
●
This is a full-size drawing (actual size)
●
Use good quality plywood or solid wood
●
Use 1/2 in (12.7mm). or 3/4 in (19.1mm).
material
●
Push stick MUST be thinner than the width
of material being cut
Drill Hole For
Hanging
Notch To Prevent
Hand From
Slipping
Cut Here
To Push 1/2
in.(12.7mm)
Wood
Cut Here To
Push 3/4 in.
(19.1mm)
Wood