Hitachi CB 520H B3 - Page 308

Table 7-28 LPAR Status on the LPAR manager System Configuration
Screen
Item
LPAR Status
Remark
Supported
LPAR
manager
Version
Activate Deactivate Failure
LP ID - Y - - 01-0X~
LP IP Address
(IPv4)
- - - displayed only 01-0X~
Subnet Mask - - - displayed only 01-0X~
Default Gateway
(IPv4)
- - - displayed only 01-0X~
SVP IP Address
(IPv4)
- - - displayed only 01-0X~
BSM1~4 IP
Address
Y Y Y - 01-0X~
BSM1~4 Alert
Port
Y Y Y - 01-0X~
Management
Path
- - - displayed only
This item is not
displayed in the
firmware
combinations
that support
change of
management
path
specification.
01-0X~
VNIC System No - Y - - 01-0X~
Alert Language - Y Y - 01-0X~
Virtual Console
Port
- Y - - 01-0X~
SYS2 Processors - Y Y - 02-62~
LP CLI1~8 IP
Address (IPv4)
Y Y Y - 01-0X~
LP-SVP
Communication
- - - displayed only 02-25~
IPv6 Static
Address
- - - displayed only 02-25~
LP IP Address
(IPv6)
- - - displayed only 02-25~
Prefix Length - - - displayed only 02-25~
Default Gateway
(IPv6)
- - - displayed only 02-25~
7-70
Operation by LPAR manager Screen
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide