7. Input/Output Setting
22
A16381TMF2
Input/Output
00-00
ALL
00-01
00-02
OK
Select Back
7. Input/Output Setting
Set Input/output from the Installation Menu.
1. Set Input/Output
Step1. Select "Installation Menu" on the Service & Installation
screen and press "OK" .
Step2. Select "Input/Output" setting and press "OK".
Step3. Press "OK".
Step4. Select the indoor unit by pressing " ", " ", " ", or " " and
press "OK".
(This screen is NOT displayed when only one indoor unit
is connected with the controller. In this case, "Step4" is
displayed.)
Step5. Press " " or " " to select the item.
Step6. Press " " or " " to change the setting.
Step7. Press "OK" and the confirmation screen is displayed.
Step8. Select "Yes" and press "OK" to confirm the setting and the
screen returns to Step2.
If "Cancel" is selected, the setting is cancelled and the
screen returns to Step2.
If there is more than one indoor unit connected to the
remote controller, the screen returns to Step3.
Press " " to return to Step4.
Installation Menu
OK
Select Back
Input/Output
Thermistor Selection
Thermistor Calibration in Controller
Function Selection
Test Run
(Mon) 16:30
(Mon) 16:30
Installation Menu
Thermistor Selection
Input/Output
Thermistor Calibration in Controller
Function Selection
Test Run
The displayed explanation is for
reference only. For details on each input/
output setting, refer to the technical
manual of each unit.
OK
OK
Select Back
Input/output : ALL
Item Setting Connector
Input 1
00: Not set
CN3 1-2
Input 2 00: Not set CN3 2-3
Output 1 00: Not set CN7 1-2
Output 2 00: Not set CN7 1-2
Output 3 00: Not set CN8 1-2
OK
Select Back
00: Not set
Input/Output
Item Setting Connector
Input 1
03
CN3 1-2
Input 2 08 CN3 2-3
Output 1 08 CN7 1-2
Output 2 08 CN7 1-2
Output 3 06 CN8 1-2
OK
Enter Back
Update setting of input/output?
Yes Cancel
OK
Select Back
Indoor unit number
(Refrigerant system number
—Address number)
Service & Installation
Check Menu
Installation Menu
Service Menu
OK
Select Back
(Mon) 16:30
To Next Page
Loading...
