Hitachi CIW03-H - NFC Setting; NFC Setup and Configuration Steps

22. Backup System Setting
A16381TMF2
39
Choose 1 System(default)
Choose 3 Systems
Choose 2 Systems
彊巡
ˌ˒ˣʷ
彊巡
ˌ˒ˣʷ
彊巡
ˌ˒ˣʷ
彊巡
ˌ˒ˣʷ
ܧ౹1
ܧ౹2
ܧ౹3
ܧ౹4
System1
System2
System3
System4
Standby
Standby
Operation
Operation
Standby
Operation
Standby
Operation
彊巡
ˌ˒ˣʷ
ˌ˒ˣʷ
彊巡
ˌ˒ˣʷ
彊巡
ˌ˒ˣʷ
彊巡
ܧ౹1
ܧ౹2
ܧ౹3
ܧ౹4
System1
System2
System3
System4
Standby
Standby
Operation
Operation
Standby
Operation
Standby
Operation
彊巡
ˌ˒ˣʷ
彊巡
ˌ˒ˣʷ
彊巡
ˌ˒ˣʷ
彊巡
ˌ˒ˣʷ
ܧ౹1
ܧ౹2
ܧ౹3
ܧ౹
4
System1
System2
System3
System4
Standby
Standby
Operation
Operation
Standby
Operation
Standby
Operation
NOTES:
•
Number of refrigerant systems to operate are not more than total connected systems.
•
Operation before 30 minutes is omitted.
4. High Load Startup
This function is to backup operation in high load.
When the setting temperature of cooling and heating are all "OFF", the high load startup is unavailable.
22.2 Set Backup System
1. Set Backup System
Step1. Select "Service Menu" on the Service & Installation screen
and press "OK".
Step2. Select "Backup System Setting" and press "OK".
Step3. Press" " or " " to select the setting item.It changes as follows:
" Enable/Disable Backup System "
↔
" Rotation Cycle Time "
↔
" No. of Refrig. Systems to Operate "
↔
" High Load Startup ".
Step4. Press "OK" to conrm the selection.
2. Enable/Disable Backup System
Step1. Select "Enable/Disable Backup System" on the backup system
setting screen and press "OK".
Step2. Press " " to select "Enable".
Step3. Press "OK" to conrm the setting.
Step4. Press " " to return to Step1.
Backup System Setting
Rotation Cycle Time
No. of Refrig. Systems to Operate
High Load Startup
Enable/Disable Backup System
OK
Select Back
Enable/Disable Backup System
OK
Select Back
Enable
Disable