STORE
...........................
.
Press the switch ~, to store the currently adjusting ;
STORED ! ~
data as follows
Item
H. Position
H.Size
V.Position
V.Size
Pincushion
Trapezoid
Right Pincushion
H. Moire Reduction
V.Moire Reduction
Colour Balance
(Red, Green, Blue)
Rotation
Right Trapezoid
Contrast
Brightness
Colour Select
Storing Condition
One setilng is allowed for each video mode.
You can store maximum 26 sets of geometry
settings including the standard settings (refer
to page 9 “STANDARD SETTINGS”).
............................
If your store is at its maximum already,
storing a setting for new video mode
overwrites the oldest user setting.
The video mode is distinguished by the
horizontal/vertical frequency and polarity
of the horizontal/vertical sync. signal.
When the video modes are almost similar
in these factors, however, the video mode:
may not be discriminated as different.
One setting is allowed to the colour
balance “No.4USER”.
One setting is allowed.
One setting is allowed.
9 It is normally not necessary to store therr
manually. No operation of about 8
seconds stores the currently adjusting
data of these items, automatically.
Restoring Condition
When the monitor detects
the same video mode.
When the colour balance
“No.4USER” is selected.
When the monitor
detects a valid signal.
RESET
● Only when you want to cancel all your storing data,
turn @l the power switch ( @ ) while pressing the
*S
switches [+J together, to reset to the original standard settings.
All your stored data will be lost and the all adjustment condition will be returned to the
original settings.
SIGNAL CHECK
.....................................
CD
CONTRAST
● To refer to the input signal condition, press the
-4~*+ ;
switch of the ~ (CONTRAST/BRIGHTNESS).
~ BRIGHTNESS ;
-4~*+ :
The horizontal frequency and vertical frequency
will be indicated.
80 &ilz/ 75Hz :
..... .. . .. . ... .. .. .. ....... . .. .. ... . .
■ Precision frequency,
Horizontal approximately * 2kHz
Sample of
Vertical approximately
“EasyMenu”
t
& 2Hz
14
.