Hitachi Compute Blade 2500 Installation Guide

2-10 Preparations
Hitachi Compute Blade Embedded 10G DCB Switch Module License Installation Guide
Compute Blade 2000
The following shows the disconnect procedure for Compute Blade 500.
Enter "exit" to exit from the 10G DCB switch module. And, enter "exit" to exit
from the CB500 management module.
Compute Blade 500
Enter "exit" to exit from the 10G DCB switch module. And, enter "exit" to exit
from the CB2500 management module.
Compute Blade 2500
sw0# exit  Enter exit
- Connection closed.
S0002 : Command succeeded.
S0000 : Command was finished.
(0)$ exit  Enter exit
sw0# exit  Enter exit
- Connection closed.
S0002 : Command succeeded.
S0000 : Command was finished.
$ exit  Enter exit
<< System Console Main Menu >>
P. Start OS console session.
SW. Start switch module console session.
S. System command mode.
X. Exit.
(P,SW,S,X) : X  Enter X

Hitachi Compute Blade 2500 Specifications

General

Brand	Hitachi
Model	Compute Blade 2500
Category	Server
Language	English