vi Preface
Hitachi Compute Blade Embedded 10G DCB Switch Module License Installation Guide
Intended Audience
This license package is for Hitachi Embedded 10G DCB Switch. This manual
provides the information necessary to install the license.
Product Version
This document revision applies to Network OS for Brocade 10Gbps DCB switch
module version v.2.0.1 kat4 or later.
Release Notes
Read the Readme for the Network OS before installing and using this product.
They may contain requirements or restrictions that are not fully described in
this document or updates or corrections to this document.
Document Organization
The following table provides an overview of the contents and organization of
this document. Click the chapter title in the left column to go to that chapter.
The first page of each chapter provides links to the sections in that chapter.
Provides what you should know before you begin to install the
license for a Hitachi Embedded 10G DCB Switch module.
Provides information on what you need to have in order to install
the license for an Embedded Switch module and describes how to
make connections.
Chapter 3. Pre-confirmation
Describes a set of procedures to check the status of the Compute
Blade.
Chapter 4. User Registration
Describes how to create and configure a user account necessary to
access the Web site for obtaining a license key.
Chapter 5. Log in the Web site
Describes how to log in to the Web site and where the Web site for
obtaining a license key is.
Chapter 6. Install the License
Describes how to install the license in the Embedded 10G DCB
Switch module.
Chapter 7. Troubleshooting
Provides lists some common troubles which you may encounter
while performing a task.
To Next Page
Loading...
