Hitachi Compute Blade 2500 Installation Guide

3-4 Pre-confirmation
Hitachi Compute Blade Embedded 10G DCB Switch Module License Installation Guide
Confirm the DCB Switch’s WWN
(1) Execute show license id command to get the WWN of the DCB Switch and
write down the value in the space for "Write down here" provided below.
Write down the WWN of the DCB Switch
where the license is to be installed.
Write down here.
The WWN of the DCB Switch is necessary to obtain the license.
Since each license only covers single DCB Switch (or WWN), if the wrong WWN is
used to obtain a license, the license may not be installed in the appropriate DCB
Switch.
Be sure to check that the WWN of the DCB Switch is correct.
switch# show license id  Enter show license id command
SwitchId LicenseId
========================================
1 10:00:00:05:1E:00:4C:80  Write down the value of WWN
Caution

Hitachi Compute Blade 2500 Specifications

General

Brand	Hitachi
Model	Compute Blade 2500
Category	Server
Language	English