18
• When entering the Passcode, capital and small letters are not
distinguished.
• If you are using a Subnet mask other than Class A, B or C, you will have to
establish the connection manually.
If the manual setting screen is displayed, please follow item 1.5.1 (3). (
22)
NOTE
If you select [Enter PassCode] at item 1.5,
the “Please enter the PassCode” screen is
displayed. Please enter the Passcode divided
4-digit each in 3 boxes (total 12-digit).
Example PASSCODE: 1234 - 5678 - 9ABC
(2) Entering the Passcode
After entering the Passcode, click the [Connect] to start the connection to the
projector.
Proceed to item 1.8 Confirming the connection to your destination. (
31)
If you click the [Back], the screen is back to item 1.5 Selecting the network
connection method. (
15)
[Troubleshooting]
Incorrect PassCode.
The incorrect Passcode was input.
Click the [Back] to return to the “Please
enter the PassCode” screen.
Check the PassCode on the projector
screen (
16) and enter the code again.
1. Connection to the network
1.5 Selecting the network connection method (continued)
To Next Page
Loading...
