24
1.6 Manual configuration
There are 3 options for the manual
configuration.
If you select Configure Network Settings
Manually, proceed to item 1.7 Configuring the
network settings manually. (
26)
• Profile (
below)
• History (
25)
• Configure Network Settings Manually (
26)
• To check the setting in a profile data, follow the process below.
1) Choose a profile data that you want to check.
2) Move the mouse cursor to the profile data, and click the right button on the
mouse to display a pop-up menu.
3) Select the “Property” in the pop-up menu, and click the left button on the
mouse.
4) The setting information of the selected profile data is shown.
• If the DHCP is set on in the projector, the network connection between the
projector and computer may not be established since IP address may be varied.
If you like to use the Profile connection, set the DHCP off in the projector.
NOTE
Selecting a profile data connect the network
with the projector.
It is required to store the profile data in
advance. (
34)
1) Select the [Profile].
2) Choose a profile data listed in the window.
3) Click the [Connect].
4) The network connection will be established.
Proceed to item 1.8 Confirming the
connection to your destination. (
31)
1.6.1 Profile connection
1. Connection to the network
To Next Page
Loading...
