26
VIDEO
DOC.CAMERA
KEYSTONE
ASPECT
SEARCH
BLANK
MUTE
MY BUTTON
COMPUTER
MY SOURCE/
AUTO
MAGNIFY
PAGE
DOWN
ON
OFF
FREEZE
UP
㧗
VOLUME
Operating
1.
Using the magnify feature
2.
3.
4.
Press the MAGNIFY ON button on the remote control.
The picture will be magnified, and the MAGNIFY dialog will
appear on the screen. When the MAGNIFY ON button is
pressed for the first time after the projector is turned on, the
picture will be zoomed by 1.5 times. On the dialog, triangle
marks to show each direction will be displayed.
The display magnification of the projector switches in order
with every press of the MAGNIFY ON button.
For computer signals, HDMI
TM
(RGB) signals, input signals from the
LAN or USB TYPE B port
1.5 times 2 times 3 times 4 times 1 time
For video signals, s-video signals, component video signals or HDMI
TM
(Component) signals
1.5 times 2 times 1 time
While the triangles are displayed on the dialog, use the ▲/▼/◄/► cursor
buttons to shift the magnifying area.
Press the MAGNIFY OFF button on the remote control to exit magnification.
● The MAGNIFY dialog will automatically disappear in several seconds with no
operation. The dialog will appear again if the MAGNIFY ON button is pressed
when the dialog has automatically disappeared.
● The magnification is automatically disabled when the displaying signal or its
display condition is changed.
● While the magnification is active, the keystone distortion condition may vary.
It will be restored when the magnification is disabled.
● Some horizontal stripes might be visible on the image while magnification is
active.
● This function is not available in the following cases:
- The USB TYPE A port is selected as the input source.
- A sync signal in the range not supported is input.
- There is no input signal.
MAGNIFY
ON/OFF button
To Next Page
Loading...
Need help?
General