Hitachi CP-A221N - Page 220

11
Command Control via the Network
When the projector connects network, the projector can be controlled with RS-
232C commands from the computer with web browser.
For details of RS-232C commands, refer to RS-232C Communication / Network
command table
(
17
).
Connection
1.
Turn off the projector and the computer.
2.
Connect the projector's LAN port and the computer's LAN port with a LAN
cable. Use the cable that fulfi lls the specifi cation shown in fi gure (Use CAT-5
or greater LAN Cable when LAN ports are used )
3.
Turn the computer on, and after the computer has started up turn the
projector on.
Command Control via the Network
LAN
LAN
LAN cable (CAT-5 or greater)