12
Microphone
system
(continued on next page)
Connecting with your devices (continued)
Setting up
• If you insert a USB storage device, such as a USB memory, into the USB TYPE
A port and select the port as the input source, you can view images stored in the
device (80).
• You can connect a dynamic microphone to the MIC port with a 3.5 mm mini-plug.
In that case, the built-in speaker outputs the sound from the microphone, even
while the sound from the projector is output. You can input line level signal to the
MIC port from equipment such as wireless microphone. In the normal mode, the
volume of the microphone can be adjusted separately from the volume of the
projector using the menu. (53)
In the standby mode, the volume of the microphone is adjustable with the
VOLUME +/- buttons on the remote control, in synchronization with the volume of
the projector. (23)
Even when the sound of projector is set to mute mode by the AUDIO SOURCE
function (53), the volume of the microphone is adjustable.
In both modes (standby or normal), the AV MUTE button on the remote control
works on the sounds of the microphone and the projector. (23)
• If a loud feedback noise is produced from the speaker, move the
microphone away from the speaker.
• This projector doesn't support plug-in power for the microphone.
NOTE
Monitor
R
L
RGB IN
Speakers
(with an amplier)
To Next Page
Loading...
Need help?
General