Hitachi CP-RX80 - INPUT Menu; Progressive; Ideo Nr, C

31
INPUT menu
INPUT menu
INPUT menu
From the INPUT menu, items shown in the table
below can be performed.
Select an item using the Ÿ/ź cursor buttons, and
press the Ź cursor button or ENTER button to
execute the item. Then perform it according to the
following table.
Item Description
PROGRESSIVE
Using the Ÿ/ź buttons switches the progress mode.
TV
Ù
FILM
Ù
OFF
• This function is performed only for the VIDEO or S-VIDEO input,
and for 480i@60 or 576i@50 signal at the COMPUTER IN input.
• When TV or FILM is selected, the screen image will be sharp.
FILM adapts to the 2-3 Pull-Down conversion system. But these
may cause a certain defect (for example, jagged line) of the picture
for a quick moving object. In such a case, please select OFF, even
though the screen image may lose sharpness.
VIDEO NR
Using the Ÿ/ź buttons switches the noise reduction mode.
HIGH
Ù
MID
Ù
LOW
• This function is performed only for the VIDEO or S-VIDEO input,
and for 480i@60 or 576i@50 signal at the COMPUTER IN input.
• When this function is excessive, it may cause a certain
degradation of the picture.
COLOR SPACE
Using the Ÿ/ź buttons switches the mode for color space.
AUTO
Ù
RGB
Ù
SMPTE240
Ù
REC709
Ù
REC601
• This item can be selected only for a computer signal or a
component video signal.
• The AUTO mode automatically selects the optimum mode.
• The AUTO operation may not work well at some signals. In such a
case, it might be good to select a suitable mode except AUTO.
(continued on next page)