30
Operating
• The projector may ignore operation by buttons while moving the lens.
• You can perform the LOAD function using LENS MEMORY button.
NOTE
Adjusting the lens (continued)
This projector is equipped with memory functions for the
lens adjustments (LENS SHIFT and LENS TYPE). Up
to 3 sets of adjustments can be stored.
To utilize the lens memory feature, press the POSITION
or FUNCTION button while the LENS SHIFT dialog is
displayed. Then the LENS MEMORY dialog will ap-
pear. The current lens adjustments are displayed on the
“CURRENT” line. The adjustments already stored in the
lens memory are displayed on the lines of SAVE and
LOAD-1 to 3.
Lens memory
SAVE:
To store the current lens adjustments, select one of the
"SAVE" options numbered 1 to 3 (number of the lens
memory) and press the ►or ENTER button.
Remember that the current data being stored of
a memory will be lost by saving new data into
the memory.
LOAD:
To recall stored adjustments, select one of the
"LOAD" options numbered 1 to 3 (number of the
lens memory) and press the ►or ENTER button.
Remember that the current adjusted condition will be lost by loading data. If you
want to keep the current adjustment, please save it before performing a LOAD
function.
CLEAR LENS MEMORY:
To clear the adjustment stored in a lens memory, select CLEAR LENS MEMORY
and press the ►or ENTER button. The CLEAR LENS MEMORY dialog will be
displayed. Select the number of the lens memory to be cleared using the ▲/▼
buttons and press the ►button. A message dialog is displayed for conrmation.
Press the ►button again to clear the lens memory.
POSITION
button
LENS MEMORY
button
FUNCTION
button
To Next Page
Loading...
