115
Message Description
The horizontal or vertical frequency of the input
signal is not within the specied range.
Please conrm the specs for your projector or the signal
source specs.
An improper signal is input.
Please conrm the specs for your projector or the signal
source specs.
The internal temperature is rising.
Please turn the power off, and allow the projector to cool
down at least 20 minutes. After having conrmed the
following items, please turn the power ON again.
• Is there blockage of the air passage aperture?
• Is the air lter dirty?
• Please use the unit within the usage temperature
parameters (0°C to 40°C or 45°C (
User's Manual
(concise))).
• Is the setting for ALTITUDE appropriate?
• Is the exhaust air (hot/cold) from peripheral
equipments blowing against the ventilation opening of
projector?
For details of ALTITUDE, refer to ALTITUDE
of SERVICE
in the OPTION menu (
93).
If the projector is used with
a wrong setting, it may cause damage to the projector
itself or the parts inside.
(continued on next page)
Troubleshooting
Related messages (continued)
To Next Page
Loading...
