78
SETUP menu
Item Description
STANDBY MODE
Using ▲/▼ buttons switches the standby mode setting between
NORMAL and SAVING.
NORMAL
ó
SAVING
When SAVING is selected, the power consumption in the standby
mode is lowered with some functional restriction as below:
• When SAVING is selected, the RS-232C communication control
except to turn the projector on and the network function are disabled
while the projector is in the standby mode. If the COMMUNICATION
TYPE in the COMMUNICATION menu is set to NETWORK
BRIDGE, all of the RS-232C commands are disabled (
96).
•
This function will be unavailable when NETWORK BRIDGE is
selected for COMMUNICATION TYPE. (
OPTION menu > SERVICE
> COMMUNICATION)
•
This function will be available only when OFF is selected for
STACK MODE. (
OPTION menu > SERVICE > COMMUNICATION
> STACK)
• When SAVING is selected, AUDIO OUT STANDBY setting of
AUDIO SOURCE (
80) is invalid, and no signal is output from
AUDIO OUT port in the standby mode.
• When SAVING is selected, STANDBY setting of MONITOR OUT
is invalid, and no signal is output from MONITOR OUT port in the
standby mode.
• When SAVING is selected, the CENTERING feature while the
projector is in the standby mode is disabled.
•
When SAVING is selected, the Status Monitor and its button
operation are unavailable while the projector is in the standby mode.
•
When SAVING is selected, the HDMI Link and HDBaseT functions
are disabled while the projector is in the standby mode.
COLOR
UNIFORMITY
Selects image level and region that are desired to be corrected, and
adjusts Color Balance.
Divides the screen into 9 regions and adjusts gain of R/G/B of each
region.
(continued on next page)
To Next Page
Loading...
