SETUP menu
Item Description
AUTO ECO MODE
Using the ▲/▼ buttons turns on/off the AUTO ECO MODE.
ON
ó
OFF
• When ON is selected, the projector will always be set to Eco mode
at start-up regardless of the ECO MODE (
below) setting. An OSD
message “AUTO ECO MODE” will be displayed for a while when
the projector starts with this function activated.
ECO MODE
Using the ◄/► buttons swithes the ECO MODE.
ECO
ó
INTELLIGENT ECO
ó
NORMAL
• When the ECO is selected, acoustic noise and screen brightness
are reduced.
• When INTELLIGENT ECO is selected, the brightness of the
lamp changes according to the level of the input signal. The lamp
becomes brighter when the input signal level is high and darker
when the level is low. If dark images are projected continuously, the
brightness of the lamp may increase to maintain its performance.
• When AUTO ECO MODE (
above) is set to ON, the projector will
always be set to Eco mode at start-up regardless this setting.
INSTALLATION
Pressing the ►button displays the dialog for changing the
INSTALLATION setting.
Use the ▲/▼ buttons to select the desired setting on the
INSTALLATION dialog, and press the ENTER button of the remote
control or the INPUT button of the projector to execute.
If Transition Detector is ON and the INSTALLATION status is
changed, the TRANSITION DETECTOR ON alarm (
77) will be
displayed when the projector is restarted.
(continued on next page)
To Next Page
Loading...
Need help?
General
