Hitachi CP-X251 - IMAGE Menu; ASPECT; OVER SCAN; V POSITION

30
IMAGE Menu
IMAGE Menu
Item Description
ASPECT
8VLQJWKHEXWWRQVŸźVZLWFKHVWKHPRGHIRUDVSHFWUDWLR
For an RGB signal
NORMAL
Ù
4:3
Ù
16:9
Ù
SMALL
For a video signal, s-video signal or component video signal
4:3
Ù
16:9
Ù
14:9
Ù
SMALL
For a no signal
¿[HG
• The NORMAL mode keeps the original aspect ratio of the signal.
OVER SCAN
8VLQJWKHEXWWRQVŸźDGMXVWVWKHRYHUVFDQUDWLR
Large (It reduces picture)
Ù
6PDOO,WPDJQL¿HVSLFWXUH
•
This item can be selected only for a video, s-video and component signal.
• When this adjustment is too large, certain degradation may appear
at the frame area of the picture. In such a case, please adjust small.
V POSITION
8VLQJWKHEXWWRQVŸźDGMXVWVWKHYHUWLFDOSRVLWLRQ
Up
Ù
Down
• Over-adjusting the vertical position may cause noise to appear
on the screen. If this occurs please reset the vertical position to the
default setting. Pressing the RESET button when V POSITION is
selected will reset the V POSITION to the default setting.
For a video signal, s-video signal or component video signal
The adjustable range of V.POSITION depends on the OVERSCAN setting.
It is not possible to adjust when the OVERSCAN is set to 10.
H POSITION
8VLQJWKHEXWWRQVŸźDGMXVWVWKHKRUL]RQWDOSRVLWLRQ
Left
Ù
Right
• Over-adjusting the horizontal position may cause noise to appear
on the screen. If this occurs please reset the horizontal position to
the default setting. Pressing the RESET button when H POSITION
is selected will reset the H POSITION to the default setting.
For a video signal, s-video signal or component video signal
The adjustable range of H.POSITION depends on the OVERSCAN setting .
It is not possible to adjust when the OVERSCAN is set to 10.
H PHASE
8VLQJWKHEXWWRQVŸźDGMXVWVWKHKRUL]RQWDOSKDVHWRHOLPLQDWHÀLFNHU
Right
Ù
Left
• This item can be selected only for an RGB signal or a component
video signal.
With the IMAGE menu, items shown in the table below can
be performed.
6HOHFWDQLWHPXVLQJWKHFXUVRUEXWWRQVŸźRQWKH
SURMHFWRURUUHPRWHFRQWURODQGSUHVVWKHFXUVRUEXWWRQŹ
on the projector or remote control, or the ENTER button
on the remote control to execute the item. Then perform it
referring to the following table.
/'07=4)$?
+/#)'

2+%674'



5'.'%6

#761#&,756':'%76'

#52'%6

18'45%#0

*2*#5'

*5+<'

*215+6+10





8215+6+10

5'672

+0276

126+10

'#5;/'07

5%4''0
