Hitachi CP-X2520 - Page 50

50
CP-X2520 ( M2-25ED ) / CP-X3020 ( M2-30ED )
5. Power Supply Block
Fasten the BALLAST HOLDER and the POWER SHIELD METAL to the POWER UNIT CIRCUIT
with four screws. (Torque: 0.39 to 0.59N㨯m)
Attach the power supply block to the BOTTOM CASE.
Fasten the power supply blockWKH$&,1/(7DQGWKH/$0362&.(7 with T2.6x12 screws.
M3x8 screw (3pcs)
M4x8 screw with washer (1pc)
POWER UNIT BLOCK
LAMP HOUSE
AC INLET
INLET METAL
T2.6x12 screw
T2.6x12 screw
T2.6x12 screw
AC INLET
Secure down the INLET
METAL to secure the AC
INLET.
Fasten to BOTTOM CASE
Secure to
LAMP HOUSE
4. POWER FAN
Put the POWER FAN onto the BALLAST HOLDER so that two bosses of the
BALLAST HOLDER fit to holes of the POWER FAN.
Fasten the POWER FAN with 2 screws.
BALLAST HOLDER
2 bosses
POWER FAN
T3x12 screw
with washer (2pcs)
Confirm that the slit of the POWER
FAN is beside the projection of a
BALLAST HOLDER after attaching
the POWER FAN.