19
CP-X608(EDX40WL)
YES
NO
Check above P.14 and P.18
NO
Setup IP of PC to “192.168.1.N”.
It may be correct after
power off/on
It may be correct after
power off/on
YES
YES
Once AC power off, and wait
until LED changes blinking to
lighting after power on.
Check connection again.
(AC power off need,Stand-by
is not enough)
YES
NO
NO
Setting of the WIRELESS
NETWORK UNIT. Change
the WIRELESS NETWORK
UNIT setting to the factory
default. (Refer Fig.2)
Did you check above P.14 and P.18 ?
YES
NO
NO
NO
YES
YES
Is MIU setup the
factory default setting?
(Refer Fig.1)
Is setting of IP on
PC “192.168.1.N” ?
(subnetmask:”255.255.255.0”)
(N:integer , 1 to 9 or 11 to 254)
(Refer Fig.3-1 to 3-4)
Click One-Click
button on MIU Live Viewer.
Is IP address “192.168.1.10”
displayed?
Turn on the
projector again, and click
FIND button on MIU Live Viewer.
Is IP address “192.168.1.10”
displayed?
When you check
connection, LED on
WIRELESS SD card lighting
continuously not blinking?
Is there
projector nearby
(within 100m) which use
same default setting?
IP:192.168.1.10, DHCP:off, CH:1, SSID:wireless,
ENCRYPTION:off, MODE,ADHOC,
NETWORK MODE:WIRELESS, SPEED:AUTO
The WIRELESS NETWORK UNIT can not be
communicated to PC when the WIRELESS
NETWORK UNIT is in a factory default settings.
A
Change IP address besides
default in MIU SETUP on
projector menu.
To Next Page
Loading...
