Hitachi CP-X608 - Page 44

44
CP-X608(EDX40WL)
6-16 Reset of the Network Web password / User ID, Network Control password
ATTENTION : Performing this operation initializes the network settings. If the projector has
the customized settings in the network, make a note of the network settings to restore
them before this operation.
1. Display the MIU SETUP menu.
2. Select “TURN OFF” in the item of DHCP.
3. Enter “255.255.255.255” in the item of IP ADDRESS.
4. Enter “255.255.255.255” in the item of SUBNET MASK.
5. Enter “255.255.255.255” in the item of DEFAULT
GATEWAY.
6. While MIU menu is displayed, press the RESET button of the remote control.
7. Press Ÿ button to execute reset.
The operation described above resets not only Web password but also NETWORK settings.
NOTE:
When you execute this reset operation with any other settings than above (described in the
step 2 to 5), the WEB password, SNTP server address, DATE AND TIME and other sched-
ule settings are not initialized, but the network settings (DHCP, IP ADDRESS, SUBNET
MASK and DEFAULT GATEWAY) are initialized.
8. If the network settings had been customized, restore them by manual operation.
MIU SETUP
DHCP
IP ADDRESS
SUBNET MASK
DEFAULT GATEWAY
TIME DIFFERENCE
DATE AND TIME
MODE
CH
ENCRYPTION
SPEED
NETWORK MODE
ON
/'07=4)$?
+/#)'
5'672
2+%674'
+0276
126+10
'#5;/'07
5%4''0
#7&+1
5'.'%6
/+7
 2%.'5524'5'06#6+10
 5'672


.+8'/1&' 
G5*16

Press RESET button
5'48+%'
+0(14/#6+10
MIU