Hitachi CP-X608 - Using the Magnify Feature; Freezing the Screen

22
Operating
Using the magnify feature
1.
Press the ON button of MAGNIFY on the remote control.
The “MAGNIFY” indication will appear on the screen
(although the indication will disappear in several seconds with
no operation), and the projector will go into the MAGNIFY
mode.
2.
8VHWKHFXUVRUEXWWRQVŸźWRDGMXVWWKH]RRPOHYHO
To move the zoom area, press the POSITION button in the MAGNIFY mode,
WKHQXVHWKHFXUVRUEXWWRQVŸźŻŹWRPRYHWKHDUHD$QGWR¿QDOL]HWKH
zoom area, press the POSITION button again.
To exit from the MAGNIFY mode and restore the screen to normal, press the
OFF button of MAGNIFY on the remote control.
Ɣ7KHSURMHFWRUDXWRPDWLFDOO\H[LWVIURPWKH0$*1,)<PRGHZKHQWKHLQSXW
signal is changed, or when the display condition is changed.
Ɣ$OWKRXJKLQWKH0$*1,)<PRGHWKHNH\VWRQHGLVWRUWLRQFRQGLWLRQPD\YDU\LW
will be restored when the projector exits from the MAGNIFY mode.
ESC MENU RESET
POSITION AUTO
MAGNIFY
MY BUTTON VOLUME
ON 1
MUTE
Freezing the screen
1.
Press the FREEZE button on the remote control.
The “FREEZE” indication will appear on the screen (although
the indication will not appear when the TURN ON is selected
to the MESSAGE item of SCREEN menu
(

42)
), and the
projector will go into the FREEZE mode.
To exit the FREEZE mode and restore the screen to normal, press the FREEZE
button again.
Ɣ7KHSURMHFWRUDXWRPDWLFDOO\H[LWVIURPWKH)5((=(PRGHZKHQWKHLQSXWVLJQDO
changes, or when one of the projector’s buttons or the remote control buttons
of STANDBY/ON, SEARCH, RGB, VIDEO, BLANK, AUTO, ASPECT, VOLUME,
MUTE, KEYSTONE, POSITION, MENU, MAGNIFY and MY BUTTON is
pressed.
Ɣ,IWKHSURMHFWRUFRQWLQXHVSURMHFWLQJDVWLOOLPDJHIRUDORQJWLPHWKH/&'SDQHO
might possibly be burned in. Do not leave the projector in the FREEZE mode
for too long.
MAGNIFY MY BUTTON VOLUME
ON 1
MUTE
OFF 2
FREEZE KEYSTONE SEARCH
NOTE • 7KH]RRPOHYHOFDQEH¿QHO\DGMXVWHG&ORVHO\ZDWFKWKHVFUHHQWR
¿QGWKHOHYHO\RXZDQW