Hitachi CP-X615 - Basic Operation; Adjusting Volume and Muting; Selecting Input Signals

17
3. Management with Web browser software
3.1 Conguring and controlling the projector via a web browser (continued)
3.1.4 Port Settings
Displays and congures communication port settings.
Item Description
Network Control Port1
(Port:23)
Congures command control port 1 (Port:23).
Port open Click [Enable] check box to use port 23.
Authentication
Click [Enable] check box when authentication is required for
this port.
Network Control Port2
(Port:9715)
Congures command control port 2 (Port:9715).
Port open Click [Enable] check box to use port 9715.
Authentication
Click [Enable] check box when authentication is required for
this port.
Image Transfer Port
(Port:9716)
Congures the image transfer port (Port:9716).
Port open Click the [Enable] check box to use port 9716.
Authentication
Click the [Enable] check box when authentication is required
for this port.
SNMP Port Congures the SNMP port.
Port open Click [Enable] check box to use SNMP.
Trap address Congures the destination of the SNMP Trap in IP format.
SMTP Port Congures the SMTP port.
Port open Click [Enable] check box to use the e-mail function.
Click [Apply] button to save the settings.
• The new conguration settings are activated after restarting the
network connection. When the conguration settings are changed, you must
restart the network connection. You can restart the network connection by
clicking [Network Restart] on the main menu.
NOTE