23
Operating
1.
Press the MENU button on the remote control or one of the cursor
buttons on the projector.
The Advanced MENU, or EASY MENU that has priority just after
powered on, will appear.
If you want to move the menu position, use the cursor buttons after
pressing the POSITION button. While the projector is displaying any
menu, the MENU button on the projector works as the cursor buttons.
Using the menu function
2.
If you want to change it to the Advanced MENU, select the
"Go to Advanced Menu..."
● Some functions cannot be performed when a certain input port is selected, or
when a certain input signal is displayed.
●
When you want to reset the operation, press the RESET button on the remote control
during the operation. Note that items whose functions are performed simultaneously
with operation (ex. LANGUAGE, H PHASE, VOLUME etc.) cannot be reset.
●
In the Advanced MENU, when you want to return to the previous display, press the
◄
cursor button on the projector or remote control, or the ESC button on the remote control.
This projector has the following menus: PICTURE, IMAGE, INPUT, SETUP, AUDIO, SCREEN, OPTION,
NETWORK, and EASY MENU. The EASY MENU consists of functions often used, and the other menus
are classified into each purpose and brought together as the Advanced Menu. Each of these menus is
operated using the same methods. The basic operations of these menus are as follows.
In the EASY MENU
3.
Use the ▲/▼ cursor buttons to select an item to operate.
4.
Use the ◄/► cursor buttons to operate the item.
5.
Press the MENU button on the remote control again to close the menu and complete this operation.
Even if you do not do anything, the dialog will automatically disappear after about 10 seconds.
2.
Use the ▲/▼ cursor buttons to select a menu.
If you want to change it to the EASY MENU, select the EASY MENU.
Then press the
►
cursor button on the projector or remote control, or the ENTER button
on the remote control to select an item. The display of the selected menu will be active.
In the Advanced MENU
3.
Use the ▲/▼ cursor buttons to select an item to operate.
Then press the
►
cursor button on the projector or remote control, or the ENTER button
on the remote control to progress. The operation menu of the selected item will appear.
4.
Use the ▲/▼ cursor buttons to operate the item.
RESET button
ENTER button
MENU button
Cursor buttons
ASPECT
ESC MENU RESET
POSITION AUTO
PUSH
ENTER
PAGE UP
PAGE DOWN
To Next Page
Loading...
Need help?
General
