SAFETY
S-25
AVOID HEATING NEAR PRESSURIZED FLUID
LINES
•
Flammable spray can be generated by heating near
pressurized fluid lines, resulting in severe burns to
yourself and bystanders.
•
Do not heat by welding, soldering, or using a torch
near pressurized fluid lines or other flammable
materials.
•
Pressurized lines can be accidentally cut when heat
goes beyond the immediate flame area. Install
temporary fire resistant guards to protect hoses or
other materials before engaging in welding, soldering,
etc..
AVOID APPLYING HEAT TO LINES
CONTAINING FLAMMABLE FLUIDS
•
Do not weld or flame cut pipes or tubes that contain
flammable fluids.
•
Clean them thoroughly with nonflammable solvent
before welding or flame cutting them.
510-E01A-0030-4
SA-030
REMOVE PAINT BEFORE WELDING OR
HEATING
•
Hazardous fumes can be generated when paint is
heated by welding, soldering, or using a torch. If inhaled,
these fumes may cause sickness.
•
Avoid potentially toxic fumes and dust.
•
Do all such work outside or in a well-ventilated area.
Dispose of paint and solvent properly.
•
Remove paint before welding or heating:
1. If you sand or grind paint, avoid breathing the dust.
Wear an approved respirator.
2. If you use solvent or paint stripper, remove stripper
with soap and water before welding. Remove solvent
or paint stripper containers and other flammable
material from area. Allow fumes to disperse at least
15 minutes before welding or heating.
511-E01A-0029-4
SA-029
To Next Page
