Third-party rack support for DB60 dense intermix drive
trays
Due to the size and weight of the DB60 dense intermix drive trays used with
VSP Gx00 models, pay close special attention when mounted in third-party
racks.
When mounting DB60 dense intermix drive trays in third-party racks, observe
the following guidelines and see the following figure.
• Use anti-tilt floor plates or ceiling-mounted fixing brackets to stabilize the
rack.
• Use a rack that is at least 40.94 in. (1040 mm) deep to accommodate the
DB60 dense intermix drive tray and cable-management arms.
• Dense tray rail kits require square mounting holed racks.
• Use a ladder to service the DB60 dense intermix drive tray if the drive tray
is mounted above shelf height RU32.
Third-party racks 115
Hitachi Virtual Storage Platform G200 Hardware Reference Guide
To Next Page
Loading...
