Hitachi G700 - Appendix F: Non-Hitachi Racks; Non-Hitachi Rack Support; Hitachi Universal V2 Rack Rail Kits

Appendix F: Non-Hitachi racks
All storage systems can be installed into non-Hitachi racks.
The following describes the requirements and guidelines for installing the storage
system into a non-Hitachi rack.
Non-Hitachi rack support
The storage system supports non-Hitachi racks that meet Hitachi specications.
Observe the following mounting guidelines for non-Hitachi racks:
■
The storage system supports any 4-post, EIA-310-D compliant rack that has adequate
airow and weight capacity.
■
PDUs must be mounted properly to avoid any issues while servicing the storage
system. The PDU receptacles must face toward the back (not toward each other). The
area behind the storage system and between the vertical 19-inch mounting posts
must be free of PDUs and cable loops.
Hitachi Universal V2 Rack rail kits
Use rail kits to mount the Hitachi Virtual Storage Platform family storage system in a
Hitachi Universal V2 Rack.
The following tables list the rail kit information for the specied storage systems.
Table 25 Rail kits
Rail kit Hitachi Universal V2 Rack Third-party rack
Controller UNI
1
UNI
1
DBS/DBSE, DBL/DBLE, and
DBF drive trays
CGR
2
UNI
1
DB60 dense intermix drive
tray
Use the rail kit supplied with the DB60 dense intermix
drive tray.
SVP server Use the rail kit supplied with the SVP server.
Notes:
1. UNI: Universal rail kit A34V-600-850-UNI.
Appendix F: Non-Hitachi racks
Hitachi Virtual Storage Platform G700 Hardware Reference Guide 110