Hitachi HUS VM - Page 373

raidcom add journal
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
volume differs from the CLPR ID of the registered
journal volume.
CMDRJE Executing 2E30 005F The specified LDEV is a remote command device.
CMDRJE
Get Command
Status
Executing/
Async
2E30 0062 The specified volume cannot be used as a journal
volume because it is an external volume that can
execute the I/O suppression mode.
CMDRJE
Get Command
Status
Executing/
Async
2E30 0064 The specified volume is a reserved volume of a
mainframe host.
CMDRJE
Get Command
Status
Executing/
Async
2E30 0065 The specified volume is used by XRC.
CMDRJE
Get Command
Status
Executing/
Async
2E30 0067 The specified volume is a volume of Just in Time
(On-demand) function.
Get Command
Status
Async 2E30 0068 The specified volume cannot be used as a journal
volume because it is used by Compatible PAV.
CMDRJE
Get Command
Status
Executing/
Async
2E30 0070 The resource group ID of the specified volume
cannot be registered because the resource group
ID is different from the resource group ID of the
other journal volume in the specified journal group.
CMDRJE
Get Command
Status
Executing/
Async
2E30 0074 The specified LDEV cannot be operated because it
is an external volume mapped for online data
migration.
Get Command
Status
Async 2E30 0084 The specified LDEV cannot be used as a journal
volume because the size of the LDEV is less than
the minimum capacity of journal volume.
CMDRJE
Get Command
Status
Executing/
Async
2E30 0086 The operation cannot be performed because the
specified volume is not the Dynamic Provisioning
V-VOL.
Get Command
Status
Async 2E30 0208 The operation cannot be performed because the
specified LDEV is a volume for which capacity
saving setting is enabled or a deduplication system
data volume.
CMDRJE Executing 2EE4 08E6 The command cannot be accepted. After a while,
execute the same command.
CMDRJE
Get Command
Status
Executing/
Async
2EE4 50EE An internal error occurred.
Call Hitachi Data Systems customer support.
CMDRJE Executing/
Async
2EE4 FEEC An internal error occurred.
Call Hitachi Data Systems customer support.
Troubleshooting
9-49
Command Control Interface User and Reference Guide